© Copyright Lenovo 2017
Table 212.
802.1X Global Configuration Options (continued)
Command Syntax and Usage
dot1x servertimeout <1‐65535>
Sets the time, in seconds, the authenticator waits for a response from the
RADIUS server before declaring an authentication timeout.
The default value is 30 seconds.
The time interval between transmissions of the RADIUS Access‐Request
packet containing the supplicant's (client's) EAP‐Response packet is
determined by the current setting of radiusserver timeout <1‐10>
(default is 3 seconds).
Command mode: Global configuration
dot1x supplicanttimeout <1‐65535>
Sets the time, in seconds, the authenticator waits for an EAP‐Response packet
from the supplicant (client) before retransmitting the EAP‐Request packet
from the authentication server.
The default value is 30 seconds.
Command mode: Global configuration
dot1x transmitinterval <1‐65535>
Sets the time, in seconds, the authenticator waits for an EAP‐Response/Identity
frame from the supplicant (client) before retransmitting an
EAP‐Request/Identity frame.
The default value is 30 seconds.
Command mode: Global configuration
[no] dot1x vlanassign
Sets the dynamic VLAN assignment status to on or off.
The default value is off.
Command mode: Global configuration
default dot1x
Resets the global 802.1X parameters to their default values.
Command mode: Global configuration
show dot1x
Displays current global 802.1X parameters.
Command mode: All
Chapter 4: Configuration Commands
411