Layer 2 Failover Configuration
Failover Trigger Configuration
448
G8264CS Command Reference for ENOS 8.4
Use these commands to configure Layer 2 Failover. For more information about
Layer 2 Failover, see "High Availability" in the Lenovo RackSwitch G8264CS
Application Guide for Lenovo Enterprise Network Operating System 8.4.
Table 237.
Layer 2 Failover Configuration Options
Command Syntax and Usage
[no] failover enable
Globally enables or disables Layer 2 Failover.
Command mode: Global configuration
show failover trigger
Displays current Layer 2 Failover parameters.
Command mode: All
The following table describes the Failover Trigger commands.
Table 238.
Failover Trigger Configuration Options
Command Syntax and Usage
[no] failover trigger <1‐8> enable
Enables or disables the Failover trigger.
Command mode: Global configuration
failover trigger <1‐8> limit <0‐1024>
Configures the minimum number of operational links allowed within each
trigger before the trigger initiates a failover event. If you enter a value of zero
(0), the switch triggers a failover event only when no links in the trigger are
operational.
Command mode: Global configuration
no failover trigger <1‐8>
Deletes the Failover trigger.
Command mode: Global configuration
show failover trigger <1‐8>
Displays the current failover trigger settings.
Command mode: All