Ip Interface Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

IP Interface Configuration
462
G8264CS Command Reference for ENOS 8.4
The G8264CS supports up to 128 IP interfaces. Each IP interface represents the
switch on an IP subnet on your network.
Interface 127 and interface 128 are reserved for switch management.
The interface option is disabled by default.
Table 250.
IP Interface Configuration Options
Command Syntax and Usage
interface ip <1‐128>
Enter IP interface mode.
Command mode: Global configuration
[no] enable
Enables or disables this IP interface.
Command mode: Interface IP
ip address <IP address> [<IP netmask>] [enable]
Configures the IP address of the switch interface, using dotted decimal
notation. The enable option also enables the IP interface.
Command mode: Interface IP
ip netmask <IP netmask>
Configures the IP subnet address mask for the interface, using dotted decimal
notation.
Command mode: Interface IP
ipv6 address <IPv6 address> [<IPv6 prefix length> [anycast]] [enable]
Configures the IPv6 address of the switch interface, using hexadecimal format
with colons. The anycast option configures the IPv6 address as an IPv6
anycast address. The enable option also enables the IP interface.
Command mode: Interface IP
ipv6 prefixlen <IPv6 prefix length (1‐128)>
Configures the subnet IPv6 prefix length. The default value is 0 (zero).
Command mode: Interface IP
ipv6 secaddr6 address <IPv6 address> <IPv6 prefix length> [anycast]
Configures the secondary IPv6 address of the switch interface, using
hexadecimal format with colons. The anycast option configures the
secondary IPv6 address as an IPv6 anycast address.
Command mode: Interface IP
no ipv6 secaddr6 address
Removes the secondary IPv6 address.
Command mode: Global configuration