Selecting A Software Image To Run - Lenovo RackSwitch G8264CS Cli Command Reference

Selecting a Software Image to Run
1. In Global Configuration mode, enter:
2. Enter the name of the image you want the switch to use upon the next boot.
Uploading a Software Image from Your Switch
1. In Privileged EXEC mode, enter:
2. Select a port type to use for uploading the image.
3. Enter the name or the IP address of the SFTP, FTP or TFTP server:
4. Enter the name of the file into which the image will be uploaded on the SFTP, FTP
or TFTP server:
5. Enter your username and password for the server, if applicable.
6. The system then requests confirmation of what you have entered. To have the file
uploaded, enter Y.
© Copyright Lenovo 2017
You can select which software image (image1 or image2) you want to run in
switch memory for the next reboot.
RS G8264CS(config)# boot image {image1|image2}
The system informs you of which image set to be loaded at the next reboot:
Next boot will use switch software image1 instead of image2.
You can upload a software image from the switch to a SFTP, FTP or TFTP server.
RS G8264CS# copy {image1|image2|boot­image} {ftp|tftp|sftp}
Port type [DATA|MGT]:
Address or name of remote host:
Destination file name:
{
User name:
<username>
image2 currently contains Software Version 6.6.0
that was downloaded at 0:23:39 Thu Jan 3, 2011.
Upload will transfer image2 (2788535 bytes) to file "image1"
on FTP/TFTP server 1.90.90.95.
Confirm upload operation (y/n) ? y
<IP address or hostname>
<filename>
|
}
<Enter>
633
Chapter 6: Boot Options