X Port Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

802.1X Port Configuration

© Copyright Lenovo 2017
The 802.1X port commands allows you to configure parameters that affect the
selected port in the switch. These settings override the global 802.1X parameters.
Table 214.
802.1X Port Options
Command Syntax and Usage
dot1x apply­global
Applies current global 802.1X configuration parameters to the port.
Command mode: Interface port
dot1x max­request <1‐10>
Sets the maximum number of times the authenticator retransmits an
EAP‐Request packet to the supplicant (client).
The default value is 2.
Command mode: Interface port
dot1x mode {auto|force­authorized|force­unauthorized}
Sets the type of access control for the port:
auto ‐ the port is unauthorized until it is successfully authorized by the

RADIUS server.
force­authorized ‐ the port is authorized unconditionally, allowing all

traffic.
force­unauthorized ‐ the port is unauthorized unconditionally.

The default value is force­authorized.
Command mode: Interface port
dot1x quiet­time <0‐65535>
Sets the time, in seconds, the authenticator waits before transmitting an
EAP‐Request/ Identity frame to the supplicant (client) after an authentication
failure in the previous round of authentication.
The default value is 60 seconds.
Command mode: Interface port
[no] dot1x re­authenticate
Sets the re‐authentication status to on or off.
The default value is off.
Command mode: Interface port
dot1x re­authentication­interval <1‐604800>
Sets the time, in seconds, the authenticator waits before re‐authenticating a
supplicant (client) when periodic re‐authentication is enabled.
The default value is 3600 seconds.
Command mode: Interface port
Chapter 4: Configuration Commands
413