Lacp Port Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

LACP Port Configuration

446
G8264CS Command Reference for ENOS 8.4
Table 235.
Link Aggregation Control Protocol Options
Command Syntax and Usage
no lacp <1‐65535>
Deletes a selected LACP LAG, based on its admin key. This command is
equivalent to disabling LACP on each of the ports configured with the same
admin key.
Command mode: Global configuration
show lacp
Display current LACP configuration.
Command mode: All
Use the following commands to configure Link Aggregation Control Protocol
(LACP) for the selected port.
Table 236.
LACP Port Options
Command Syntax and Usage
lacp key <1‐65535>
Set the admin key for this port. Only ports with the same admin key and oper key
(operational state generated internally) can form a LACP LAG group.
Command mode: Interface port/Interface portchannel
default lacp key
Resets the LACP admin key of the port to the default value.
Command mode: Interface port/Interface portchannel
lacp mode {off|active|passive}
Set the LACP mode for this port, as follows:
off turns LACP off for this port. You can use this port to manually

configure a static LAG.
active turns LACP on and set this port to active. Active ports initiate

LACPDUs.
passive turns LACP on and set this port to passive. Passive ports do not

initiate LACPDUs, but respond to LACPDUs from active ports.
The default value is off.
Command mode: Interface port/Interface portchannel
default lacp mode
Resets the LACP mode of the port to its default value.
Command mode: Interface port/Interface portchannel