HP FlexNetwork MSR Series Command Reference Manual page 476

seq-number: Specifies an IPsec policy entry by its sequence number in the range of 1 to 65535.
Usage guidelines
If you do not specify any parameters, this command displays information about all IPsec policies.
If you specify an IPsec policy name and a sequence number, this command displays information
about the specified IPsec policy entry. If you specify an IPsec policy name without any sequence
number, this command displays information about all IPsec policy entries with the specified name.
Examples
# Display information about all IPv4 IPsec policies.
<Sysname> display ipsec policy
-------------------------------------------
IPsec Policy: mypolicy
-------------------------------------------
-----------------------------
Sequence number: 1
Mode: Manual
-----------------------------
The policy configuration is incomplete:
Description: This is my first IPv4 manual policy
Security data flow:
Remote address: 2.5.2.1
Transform set: transform
Inbound AH setting:
AH SPI: 1200 (0x000004b0)
AH string-key: ******
AH authentication hex key:
Inbound ESP setting:
ESP SPI: 1400 (0x00000578)
ESP string-key:
ESP encryption hex key:
ESP authentication hex key:
Outbound AH setting:
AH SPI: 1300 (0x00000514)
AH string-key: ******
AH authentication hex key:
Outbound ESP setting:
ESP SPI: 1500 (0x000005dc)
ESP string-key: ******
ESP encryption hex key:
ESP authentication hex key:
-----------------------------
ACL not specified
Incomplete transform-set configuration
458