HP FlexNetwork MSR Series Command Reference Manual page 747

Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays information for all cards. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays information for all member devices. (Centralized devices in IRF
mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
information for all cards. (Distributed devices in IRF mode.)
source-ip start-source-ip [ end-source-ip ]: Specifies a source IPv4 address or IPv4 address range
for a multicast session from the initiator to the responder. The start source-ip argument specifies the
start source IPv4 address. The end source-ip argument specifies the end source IPv4 address.
destination-ip start-destination-ip [ end-destination-ip ]: Specifies a destination IPv4 address or
IPv4 address range for a multicast session from the initiator to the responder. The start destination-ip
argument specifies the start destination IPv4 address. The end destination-ip argument specifies the
end destination IPv4 address.
protocol { dccp | icmp | raw-ip | sctp | tcp | udp | udp-lite }: Specifies an IPv4 transport layer
protocol, including DCCP, ICMP, RawIP, SCTP, TCP, UDP, and UDP-Lite.
source-port source-port: Specifies a source port by its number. The source-port argument specifies
the source port of a multicast session from the initiator to the responder. The value range for the
source-port argument is 0 to 65535.
destination-port destination-port: Specifies a destination port by its number. The destination-port
argument specifies the destination port of a multicast session from the initiator to the responder. The
value range for the destination-port argument is 0 to 65535.
verbose: Displays detailed information about IPv4 multicast session entries. If you do not specify
this keyword, the command displays brief information about IPv4 multicast session entries.
Usage guidelines
If you do not specify any parameters, this command displays all IPv4 multicast session entries.
Examples
# (Centralized devices in standalone mode.) Display brief information about all IPv4 multicast
session entries.
<Sysname> display session table multicast ipv4
Slot 0:
Inbound initiator:
Source
Destination IP/port: 232.0.0.1/1025
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: UDP(17)
Inbound interface: GigabitEthernet1/0/1
Outbound interface list:
IP/port: 3.3.3.4/1609
729