Session Aging-Time Application - HP FlexNetwork MSR Series Command Reference Manual

Examples
# Clear all IPv6 multicast session entries.
<Sysname> reset session table multicast ipv6
# Clear the IPv6 multicast session entries with the source IP address of 2011::0002.
<Sysname> reset session table multicast ipv6 source-ip 2011::0002
Related commands
display session table multicast ipv6

session aging-time application

Use session aging-time application to set the aging time for sessions of an application layer
protocol or an application.
Use undo session aging-time application to restore the default. If you do not specify an
application layer protocol or an application, this command restores the default aging time for all
sessions of the supported application layer protocols and applications.
Syntax
session aging-time application application-name time-value
undo session aging-time application [ application-name ]
Default
The aging time is 1200 seconds for sessions of application layer protocols or applications except for
the following sessions:
•
BOOTPC sessions: 120 seconds.
•
BOOTPS sessions: 120 seconds.
•
DNS sessions: 1 second.
•
FTP sessions: 3600 seconds.
•
FTP-DATA sessions: 240 seconds.
•
GTP-CONTROL sessions: 60 seconds.
•
GTP-USER sessions: 60 seconds.
•
GPRS-DATA sessions: 60 seconds.
•
GPRS-SIG sessions: 60 seconds.
•
H.225 sessions: 3600 seconds.
•
H.245 sessions: 3600 seconds.
•
HTTPS sessions: 600 seconds.
•
ILS sessions: 3600 seconds.
•
L2TP sessions: 120 seconds.
•
MGCP-CALLAGENT sessions: 60 seconds.
•
MGCP-GATEWAY sessions: 60 seconds.
•
NETBIOS-DGM sessions: 3600 seconds.
•
NETBIOS-NS sessions: 3600 seconds.
•
NETBIOS-SSN sessions: 3600 seconds.
•
NTP sessions: 120 seconds.
•
PPTP sessions: 3600 seconds.
•
QQ sessions: 120 seconds.
750