HP FlexNetwork MSR Series Command Reference Manual page 244

network-operator
Parameters
all: Displays all portal packet filtering rules, including dynamic and static portal packet filtering rules.
dynamic: Displays dynamic portal packet filtering rules, which are generated after users pass portal
authentication. These rules allow packets with specific source IP addresses to pass the interface.
static: Displays static portal packet filtering rules, which are generated after portal authentication is
enabled. The interface filters packets by these rules when portal authentication is enabled.
ap ap-name: Specifies an AP by its name, a case-insensitive string of 1 to 64 characters. Valid
characters are letters, digits, underscores (_), left brackets ([), right brackets (]), slashes (/), and
minus signs (-).
radio radio-id: Specifies a radio by its ID. The value range for the radio ID varies by device model. If
you do not specify a radio, this command displays portal packet filtering rules for all radios of the AP.
The following matrix shows the ap ap-name [ radio radio-id ] option and hardware compatibility:
Hardware
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A)
MSR958 (JH300A/JH301A)
MSR1002-4/1003-8S
MSR2003
MSR2004-24/2004-48
MSR3012/3024/3044/3064
MSR4060/4080
interface interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays portal packet filtering rules for all cards. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays portal packet filtering rules for all member devices. (Centralized
devices in IRF mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
portal packet filtering rules for all cards. (Distributed devices in IRF mode.)
Examples
# (Centralized devices in standalone mode.) Display all portal packet filtering rules on
GigabitEthernet 1/0/1. (Wired application).
<Sysname> display portal rule all interface gigabitethernet 1/0/1
IPv4 portal rules on GigabitEthernet1/0/1:
Rule 1
Type
Action
Protocol
Status
Source:
IP
: Static
: Permit
: Any
: Active
: 0.0.0.0
226
Option compatibility
•
MSR954 (JH297A/JH298A/JH299A): Yes
•
MSR954 (JH296A/JH373A): No
No
No
Yes
Yes
Yes
No