Accelerate - HP FlexNetwork MSR Series Command Reference Manual

Object policy commands
Commands and descriptions for centralized devices apply to the following routers:
•
MSR1002-4/1003-8S.
•
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
•
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A).
•
MSR958 (JH300A/JH301A).
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

accelerate

Use accelerate to enable rule matching acceleration for an object policy.
Use undo accelerate to disable rule matching acceleration for an object policy.
Syntax
accelerate
undo accelerate
Default
Rule matching acceleration is disabled for an object policy.
Views
Object policy view
Predefined user roles
network-admin
Usage guidelines
Insufficient hardware resources cause acceleration failures. When the system has sufficient
hardware resources, acceleration can take effect again under either of the following conditions:
•
You change or add rules for the policy.
•
You use this command to enable rule matching acceleration again.
After you enable rule matching acceleration, the following situations might occur:
•
Acceleration fails, and the matching process runs without acceleration.
•
Acceleration succeeds, and the matching process is accelerated. In this scenario, if you change
or add a rule that causes resource insufficiency, the rule does not take effect.
Examples
# Disable rule matching acceleration for IPv4 object policy op.
<Sysname> system-view
[Sysname] object-policy ip op
[Sysname-object-policy-ip-op] undo accelerate
Related commands
display object-policy accelerate
792