Display Connection-Limit Statistics - HP FlexNetwork MSR Series Command Reference Manual

Slot 2:
Current limit statistic nodes count is 1.
# (Centralized devices in IRF mode.) Display the number of limit rule-based statistics sets on IRF
member device 2.
<Sysname> display connection-limit ipv6-stat-nodes global slot 2 count
Slot 2:
Current limit statistic nodes count is 0.
# (Distributed devices in IRF mode.) Display the number of limit rule-based statistics sets of IRF
member device 1 on the card in slot 2.
<Sysname> display connection-limit ipv6-stat-nodes global chassis 1 slot 2 count
Slot 2 in chassis 1:
Current limit statistic nodes count is 0.
Table 113 Command output
Field
Src IP address
Dst IP address
VPN instance
Service
Limit rule ID
Sessions
Hi/Lo
Sessions count
Sessions limit rate
New session flag
Related commands
connection-limit apply global ipv6-policy
connection-limit apply ipv6-policy
connection-limit ipv6-policy
limit

display connection-limit statistics

Use display connection-limit statistics to display the connection limit statistics globally or on an
interface.
Description
Source IP address.
Destination IP address.
MPLS L3VPN instance to which the IP address belongs. Two hyphens (--)
indicates that the IP address is on the public network.
Protocol name and service port number.
For an unwell-known protocol, this field displays unknown(xx).The cross signs
(xx) indicates the protocol number. For the ICMP protocol, the protocol number is
the decimal digits that are converted from the hexadecimal contents of the type
and code fields.
ID of the matched rule. The ACL number of the rule is enclosed in parentheses.
threshold
Upper and lower connection limits.
Number of current connections.
Maximum number of connections established per second.
Whether or not new connections can be created:
•
Permit—New connections can be created.
•
Deny—New connections cannot be created.
NOTE:
When the number of connections reaches the upper limit, this field displays
Permit although new connections are not allowed. This field displays Deny only
when the number of connections exceeds the upper limit.
770