Display Portal User - HP FlexNetwork MSR Series Command Reference Manual

Field
Status
Exclude-attribute
Related commands
portal enable
portal server
server-detect (portal authentication server view)
user-sync

display portal user

Use display portal user to display information about portal users.
Syntax
display portal user { all | ap ap-name [ radio radio-id ] | interface interface-type interface-number |
ip ipv4-address | ipv6 ipv6-address | pre-auth [ interface interface-type interface-number | ip
ipv4-address | ipv6 ipv6-address ] } [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
all: Displays information about all portal users.
ap ap-name: Specifies an AP by its name, a case-insensitive string of 1 to 64 characters. Valid
characters are letters, digits, underscores (_), left brackets ([), right brackets (]), slashes (/), and
minus signs (-).
radio radio-id: Specifies a radio by its ID. The value range for the radio ID varies by device model. If
you do not specify a radio, this command displays information about portal users for all radios of the
AP.
The following matrix shows the ap ap-name [ radio radio-id ] option and hardware compatibility:
Hardware
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A)
MSR958 (JH300A/JH301A)
MSR1002-4/1003-8S
MSR2003
Description
Reachability status of the portal authentication server:
•
N/A—Portal authentication server detection is disabled. Reachability status
of the server is unknown.
•
Up—Portal authentication server detection is enabled. The server is
reachable.
•
Down—Portal authentication server detection is enabled. The server is
unreachable.
Attributes that are not carried in portal protocol packets sent to the portal
authentication server.
239
Option compatibility
Yes
No
No
Yes