Session Log Flow-Begin - HP FlexNetwork MSR Series Command Reference Manual

[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] session log enable ipv4 inbound
# Enable session logging on GigabitEthernet 1/0/2 for IPv4 sessions that match ACL 2050 in the
outbound direction.
<Sysname> system-view
[Sysname] session log flow-begin
[Sysname] session log flow-end
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] session log enable ipv4 acl 2050 outbound
# Enable session logging on GigabitEthernet 1/0/3 for IPv6 sessions that match ACL 2050 in the
outbound direction.
<Sysname> system-view
[Sysname] session log flow-begin
[Sysname] session log flow-end
[Sysname] interface gigabitethernet 1/0/3
[Sysname-GigabitEthernet1/0/3] session log enable ipv6 acl 2050 outbound
Related commands
session log bytes-active

session log flow-begin

session log flow-end
session log packets-active
session log time-active
session log flow-begin
Use session log flow-begin to enable logging for session creation.
Use undo session log flow-begin to disable logging for session creation.
Syntax
session log flow-begin
undo session log flow-begin
Default
Logging for session creation is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
For the device to output a session log when a session entry is created, make sure both session
logging and logging for session creation are enabled.
Examples
# Enable logging for session creation.
<Sysname> system-view
[Sysname] session log flow-begin
755