Ping Test; Figure 4.125 Diagnostics > Ping Test - Advantech EKI-7428 Series User Manual

The following table describes the items in the previous figure.
Item
Port
Copper Test
The ensuing table for Test Result settings are informational only: Port, Channel A,
Cable Length A, Channel B, Cable Length B, Channel C, Cable Length C, Channel D
and Cable Length D.
4.10.2

Ping Test

The Ping Test page allows you to configure the test log page.
To access this page, click Diagnostics > Ping Test.
The following table describes the items in the previous figure.
Item
IP Address
Count
Interval (in sec)
EKI-7428 Series User Manual
Description
Click the drop-down menu to select a pre-defined port for diagnostic
testing. Giga ports are displayed with a channel A to D designation.
Click Copper Test to display the test result for the selected port.
Figure 4.125 Diagnostics > Ping Test
Description
Enter the IP address or host name of the station to ping. The initial
value is blank. The IP Address or host name you enter is not retained
across a power cycle. Host names are composed of series of labels
concatenated with periods. Each label must be between 1 and 63
characters long, maximum of 64 characters.
Enter the number of echo requests to send. The default value is 4.
The value ranges from 1 to 5. The count entered is not retained
across a power cycle.
Enter the interval between ping packets in seconds. The default value
is 1. The value ranges from 1 to 5. The interval entered is not retained
across a power cycle.
114