Table of Contents
Advertisement
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
prefix-list test in
neighbor prefix-list (IPv6 Address Family
Configuration)
In IPv6 address family configuration mode, the neighbor prefix-list command
specifies an IPv6 prefix list to filter routes received from or advertised to a
given peer.
Syntax
neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
no neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
•
ip-address—The neighbor's IPv4 address.
•
prefix-list-name—The name of an IP prefix list.
•
ipv6-address—The neighbor's IPv6 address. If the neighbor's IPv6 address
is a link local address, the local interface must also be specified. This
command is available in IPv6 address family mode.
•
interface vlan vlan-id—The local interface/VLAN ID over which the IPv6
neighbor can be reached. Range: 1-4093.
•
in—Apply the prefix list to advertisements received from this neighbor.
•
out—Apply the prefix list to advertisements to be sent to this neighbor.
Default Configuration
No prefix list is configured.
Command Mode
IPv6 Address Family Configuration mode
Layer 3 Routing Commands
1288
Advertisement
Table of Contents
