Dell N1100-ON Reference Manual page 1364

updates the BGP route table, and updates the common RIB. Phase 3 is run
independently for each outbound update group and determines which routes
should be advertised to neighbors in each group. Each entry in the table
shows statistics for one phase of the decision process. The table shows the 20
most recent decision process runs, with the most recent information at the
end of the table.
Syntax
show ip bgp [vrf vrf-name] statistics
• vrf vrf-name — Displays the aggregate address information associated
with the named VRF.
Default Configuration
By default, information about the global VRF is shown.
Command Mode
User Exec mode, Privileged Exec mode, Global Config mode and all sub-
modes.
User Guidelines
If the vrf-name argument is specified, information pertaining to that VRF is
displayed.
The following information is displayed.
Fields
Delta T
Phase
Upd Grp
GenId
Description
How long since the decision process was run.
hours:minutes:seconds if the elapsed time is less than 24
hours. Otherwise, days:hours.
The phase of the decision process that was run.
Outbound update group ID. Only applies when phase 3
is run.
Generation ID of BGP routing table when decision
process was run. The generation ID is incremented each
time phase 2 of the decision process is run and when
there is a change to the status of aggregate addresses.
Layer 3 Routing Commands
1364