Ip As-Path Access-List - Dell N1100-ON Reference Manual

Syntax
enable
no enable
Default Configuration
By default, BGP is enabled once the administrator has specified the local AS
number with the router bgp command and configured a router id with bgp
router-id.
Command Mode
BGP Router Configuration mode
User Guidelines
When disabling BGP using no enable, BGP retains its configuration. The no
router bgp command resets all BGP configuration to default values.
When BGP is administratively disabled, BGP sends a NOTIFICATION
message to each peer with a Cease error code.
The no enable command persists in the running-config (and startup-config)
only when a router-id has assigned using the bgp router-id command. If no
router-id has been assigned, the administrative state will not appear in the
running-config or in the startup-config.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#enable

ip as-path access-list

Use this command to create an AS path access list. To delete an AS path
access list, use the no form of this command.
Syntax
ip as-path access-list as-path-list-number { permit | deny } regexp
1248
Layer 3 Routing Commands