Dell N1100-ON Reference Manual page 1352

Neighbor Capabilities
Next Hop Self
Update Source
Local Interface Address
Configured Hold Time
Configured Keep Alive
Time
Negotiated Hold Time
Keep Alive Time
Prefix Limit
Prefix Warning Threshold Percentage of the prefix limit that causes a warning
Optional capabilities reported by the neighbor,
recognized and accepted by this router. Codes listed in
the show output are as follows:
• MP: Multiprotocol
• RF: Route Refresh
This version of Dell EMC Networking does not support
any multiprotocol AFI/SAFI pairs other than IPv4
unicast. The presence of this capability does not imply
otherwise.
If the local router is configured to advertise one of its
own IP addresses as the BGP Next Hop when
advertising a path learned from an external peer.
The configured value for the source IP address of
packets sent to this peer. This field is only included in
the output if the update source is configured.
The IPv4 address used as the source IP address in
packets sent to this neighbor.
The time, in seconds, that this router proposes to this
neighbor as the hold time
The configured KEEPALIVE interval for this neighbor.
The minimum configured hold time and the hold time
in the OPEN message received from this neighbor. If the
local router does not receive a KEEPALIVE or UPDATE
message from this neighbor within this interval of time,
the local router drops the adjacency. This field is only
shown if the adjacency state is OPEN CONFIRM or
greater.
The number of seconds between KEEPALIVE messages
sent to this neighbor. This field is only shown if the
adjacency state is OPEN CONFIRM or greater.
The maximum number of prefixes this router is willing
to accept from this neighbor.
message to be logged.
Layer 3 Routing Commands
1352