Chapter 58 Examples: Bridging And Vlan Configuration - Dell PowerConnect J-EX4200-24T Software Manual

CHAPTER 58
Examples: Bridging and VLAN
Configuration
Example: Setting Up Basic Bridging and a VLAN for a J-EX Series Switch
Requirements
Example: Setting Up Basic Bridging and a VLAN for a J-EX Series Switch on page 1063
Example: Setting Up Bridging with Multiple VLANs for J-EX Series Switches on page 1070
Example: Connecting an Access Switch to a Distribution Switch on page 1078
Example: Configure Automatic VLAN Administration Using GVRP on page 1087
Example: Configuring Redundant Trunk Links for Faster Recovery on page 1101
Example: Setting Up Q-in-Q Tunneling on J-EX Series Switches on page 1105
Example: Configuring a Private VLAN on a J-EX Series Switch on page 1107
Example: Using Virtual Routing Instances to Route Among VLANs on J-EX Series
Switches on page 1112
Example: Configuring Automatic VLAN Administration Using MVRP on J-EX Series
Switches on page 1115
Example: Configuring Layer 2 Protocol Tunneling on J-EX Series Switches on page 1126
J-EX Series switches use bridging and virtual LANs (VLANs) to connect network devices
in a LAN—desktop computers, IP telephones, printers, file servers, wireless access points,
and others—and to segment the LAN into smaller bridging domains. The switch's default
configuration provides a quick setup of bridging and a single VLAN.
This example describes how to configure basic bridging and VLANs for a J-EX Series
switch:
Requirements on page 1063
Overview and Topology on page 1064
Configuration on page 1065
Verification on page 1069
This example uses the following software and hardware components:
1063