Name (Vlan Configuration) - Dell Networking 7048 Reference Manual

Uplink Port Behavior
If a single-tagged (SP tagged) or double-tagged (SP tag as outer tag) packet
ingresses an uplink port, the switch passes it through unchanged to the
respective access or uplink ports.
If an untagged or single tagged (802.1Q tagged) packet ingresses an uplink
port, the switch tags it with the configured ethertype and service provider
VLAN ID taken from the ingress port PVID.
Access Port Behavior
Ingress packets on an access port are always tagged by the switch. Packets are
tagged on ingress with the configured ethertype and the service provider ID
taken from the PVID. On egress, the access port strips all (SP) tags belonging
to service provider VLANS.
Example
The following example displays how to enable Double VLAN Tunneling at
gigabit ethernet port 1/0/1.
console(config-if-1/0/1)#mode dvlan-tunnel

name (VLAN Configuration)

Use the name command in VLAN Configuration mode to configure the
VLAN name. To return to the default configuration, use the no form of this
command.
NOTE: This command cannot be configured for a range of interfaces (range
context).
Syntax
vlan–name
name
no name
Parameter Description
Parameter
vlan–name
Description
The name of the VLAN. Must be 1–32 characters in length.
VLAN Commands
813