Table of Contents
Advertisement
System Overview
Front Panel
LED Indicators:
Power: Steady green light indicates a proper connection to a power source.
Status: Blinking green light indicates that the system is in the process of initializing. It turns
steady-on when the system is in operation state.
Back Panel
1.
Restart / Reset Button: To restart the system, press and hold the button for more than 5 seconds and
release the button after the status LED on the front panel starts blinking. To reset the system to factory
default settings, press and hold the button for more than 10 seconds and release the button after the
status LED turns from blinking to off.
2.
Port5 – Port2: RJ-45 ports (10/100/1000 Base-T) for the downlink Ethernet connection (LAN4 – LAN1).
Downlink devices such as APs and client PCs can be attached here. Note: In the Web Management
Interface, there is an option to switch the role of Port2 from the downlink port (LAN1) to the uplink port
(WAN2).
3.
Port1: RJ-45 port (10/100/1000 Base-T) for the uplink Ethernet connection (WAN1). It is the default port
that can pass all traffic to an uplink device, such as the xDSL modem / router.
4.
USB: USB port reserved for future use.
5.
Power: Button to power on/off the system.
6.
Power Socket: Socket to attach 12V/1A power adapter.
Do not power off the device after restarting or resetting the device. The process takes approximately
two minutes to complete.
②
Quick Installation Guide
EWS100 ENGLISH
Advertisement
Table of Contents
