Connecting An Mx960 Ac Power Supply Cord; Replacing An Mx960 Dc Power Supply Cable - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Connecting an MX960 AC Power Supply Cord

Related
Documentation

Replacing an MX960 DC Power Supply Cable

404
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
3.
ESD points on the chassis.
Unplug the power cord from the appliance inlet on the power supply.
4.
To connect the AC power cord:
Locate a replacement power cord with the type of plug appropriate for your
1.
geographical location (see
page 165).
Plug the replacement power cord into the corresponding appliance inlet located in
2.
the chassis directly above the power supply.
Insert the power cord plug into an external AC power source receptacle.
3.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated customer site circuit breaker. We recommend that
you use a 15 A (250 VAC) minimum, or as required by local code.
Dress the power cord appropriately. Verify that the power cord does not block the air
4.
exhaust and access to router components, or drape where people could trip on it.
Move the AC input switch in the chassis above the power supply to the on (
5.
and observe the status LEDs on the power supply faceplate. If the power supply is
correctly installed and functioning normally, the
and the LED is not lit.
PS FAIL
Preventing Electrostatic Discharge Damage to an MX960 Router
AC Power Cord Specifications for the MX960 Router on page 165
MX960 AC Power Supply Description on page 98
MX960 AC Power Electrical Safety Guidelines and Warnings
Replacing an MX960 AC Power Supply on page 391
1. Disconnecting an MX960 DC Power Supply Cable on page 405
Connecting an MX960 DC Power Supply Cable on page 406
2.
"AC Power Cord Specifications for the MX960 Router" on
AC OK
Copyright © 2017, Juniper Networks, Inc.
)position
—
and DC OK LEDs light steadily,