Installing An Mx960 Fan Tray; Figure 91: Installing The Air Filter - Juniper MX960 Hardware Manual

Related
Documentation

Installing an MX960 Fan Tray

Copyright © 2017, Juniper Networks, Inc.
Lower the cable manager back into position.
5.
Rearrange the cables in the cable manager.
6.

Figure 91: Installing the Air Filter

Preventing Electrostatic Discharge Damage to an MX960 Router
Removing the Normal-Capacity MX960 Air Filter on page 325
Maintaining the MX960 Air Filter on page 446
To install a fan tray (see Figure 92 on page 268
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the fan tray on each side, and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screws on each side of the fan tray faceplate to secure it in the
3.
chassis.
Lower the cable manager back into position, if necessary.
4.
Chapter 21: Installing Components
and Figure 93 on page 269):
267