Juniper MX960 Hardware Manual page 309

Copyright © 2017, Juniper Networks, Inc.
CAUTION: Slide the MIC straight into the slot to avoid damaging the
components on the MIC.
Verify that the ejector lever is engaged by pushing it towards the MPC faceplate.
7.
If the MIC uses fiber-optic cable, remove the rubber safety cap from each transceiver
8.
and the end of each cable.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
Insert the appropriate cables into the cable connectors on the MIC.
9.
Arrange each cable to prevent the cable from dislodging or developing stress points.
10.
Secure the cable so that it is not supporting its own weight as it hangs to the floor.
Place excess cable out of the way in a neatly coiled loop.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the MIC online:
11.
Press its online/offline button. Use a narrow-ended tool that fits inside the opening
that leads to the button. Press the button until the MIC
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot mic-slot mic-slot online
For more information about the command, see the
Chapter 21: Installing Components
OK/FAIL LED lights green.
CLI Explorer .
279