Installing an MX960 DPC
Copyright © 2017, Juniper Networks, Inc.
Do not stack DPCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat,
stable surface.
If you are not reinstalling a DPC into the emptied DPC slot within a short time, install
11.
a blank DPC panel over the slot to maintain proper airflow in the DPC card cage.
CAUTION:
After removing a DPC from the chassis, wait at least 30 seconds
before reinserting it, removing a DPC from a different slot, or inserting a
DPC into a different slot.
Figure 146: Removing a DPC
A DPC weighs up to 14.5 lb (6.6 kg). Be prepared to accept its full weight.
Chapter 25: Replacing Line Card Components
357