Ramp Warning; Rack-Mounting And Cabinet-Mounting Warnings - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Ramp Warning

Related
Documentation

Rack-Mounting and Cabinet-Mounting Warnings

536
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
General Safety Guidelines and Warnings on page 529
Installation Instructions Warning on page 534
Grounded Equipment Warning on page 540
Ensure that the rack or cabinet in which the device is installed is evenly and securely
supported. Uneven mechanical loading could lead to a hazardous condition.
WARNING: To prevent bodily injury when mounting or servicing the device
in a rack, take the following precautions to ensure that the system remains
stable. The following directives help maintain your safety:
The device must be installed in a rack that is secured to the building
structure.
The device should be mounted at the bottom of the rack if it is the only unit
in the rack.
Copyright © 2017, Juniper Networks, Inc.