Table 97: Mounting Hardware Hole Locations For Center-Mounting In An Open-Frame Rack - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
200
Table 97: Mounting Hardware Hole Locations for Center-Mounting in an
Open-Frame Rack
Hole Distance Above U Division
30 17.26 in. (43.8 cm)
27 15.51 in. (39.4 cm)
24 13.76 in. (34.9 cm)
21 12.01 in. (30.5 cm)
18 10.26 in. (26.0 cm)
15 8.51 in. (21.6 cm)
12 6.76 in. (17.1 cm)
9 5.01 in. (12.7 cm)
6 3.26 in. (8.3 cm)
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
1 0.25 in. (0.6 cm)
To install the large mounting shelf (see
On the rear of each rack rail, partially insert a mounting screw into the highest hole
1.
specified in Table 97 on page 200
Install the large shelf on the rack. Hang the shelf over the mounting screws using the
2.
keyhole slots located near the top of the large shelf flanges.
Partially insert screws into the open holes in the flanges of the large shelf.
3.
Tighten all the screws completely.
4.
Large Shelf
9.86 U
X
8.86 U
X
7.86 U
X
6.86 U
X
5.86 U
X
4.86 U
X
3.86 U
X
2.86 U
X
1.86 U
X
0.86 U
X
0.50 U
X
0.14 U
Figure 54 on page
for the large shelf.
Copyright © 2017, Juniper Networks, Inc.
201):