Figure 184: Removing A Dc Power Supply From The Mx960 Router - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
480

Figure 184: Removing a DC Power Supply from the MX960 Router

Remove the blank panel over the power distribution module, and store for later reuse.
Use the following procedures to install the MX960 high-capacity AC power supplies for
power supply in slots 0, 1, 2, and 3, where present.
NOTE: During the upgrade process, you can simultaneously run
normal-capacity and high-capacity power supplies. However, it is
recommended to upgrade all power supplies to high-capacity power supplies.
To install an MX960 high-capacity AC power supply, use the following procedure (see
Figure 71 on page 229).
Verify that the power switch on the power supply is in the off (
1.
Ensure that the release lever below the empty power supply slot is locked in the
2.
counterclockwise position (see Figure 71 on page 229).
Copyright © 2017, Juniper Networks, Inc.
) position.
O