MX960 3D Universal Edge Router Hardware Guide
Related
Documentation
Tools and Parts Required for MX960 Router Connections
Related
Documentation
264
Table 100: Field-Replaceable Units
Hot-Removable and Hot-Insertable FRUs
Air filter
Craft interface
Backup Switch Control Board (SCB) (if
redundant)
Master Switch Control Board (SCB) (if
nonstop active routing is configured)
Backup Routing Engine (if redundant)
Master Routing Engine (if nonstop active
routing is configured)
Dense Port Concentrators (DPCs)
Flexible PIC Concentrators (FPCs)
Modular Port Concentrators (MPCs)
Modular Interface Cards (MICs)
PICs
AC and DC power supplies (if redundant)
Fan tray
Taking an MX960 Host Subsystem Offline
Tools and Parts Required to Replace MX960 Hardware Components
Replacing the MX960 Craft Interface on page 307
Replacing an MX960 Fan Tray on page 327
Replacing the MX960 Air Filter on page 325
To connect the router to management devices and line cards, you need the following
tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (–) screwdriver
2.5-mm Phillips (+) screwdriver
Wire cutters
Electrostatic discharge (ESD) grounding wrist strap
Connecting the MX960 Router to a Network for Out-of-Band Management on page 248
Connecting the MX960 Router to a Management Console or Auxiliary Device on page 248
Connecting an MX960 Router to an External Alarm-Reporting Device on page 249
Hot-Pluggable FRUs
Master Switch Control Board (SCB) (if
nonstop active routing is not configured)
Master Routing Engine (if nonstop active
routing is not configured)
Switch Control Board (SCB) (nonredundant)
Routing Engine (nonredundant)
Solid-state drives (SSDs) of Routing Engines
Copyright © 2017, Juniper Networks, Inc.