Installing An Mx960 Mic; Figure 98: Installing The Septum - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Installing an MX960 MIC

278
To install a MIC (see Figure 99 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If you have used a dual-wide MIC and are now replacing it with two "single" MICs,
2.
install the septum (see
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in "Removing an MX960 MPC" on page
Position the septum in the center of the MPC so that it lines up with holes labeled
b.
on the top of the MPC.
S
Insert a screw into each of the two holes labeled
c.
On the bottom of the MPC, insert a screw into each of the four holes labeled
d.
then tighten completely.
Install the MPC as described in
e.

Figure 98: Installing the Septum

Slide septum
into MPC.
Install two
screws.
If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
3.
on the faceplate. Install a cap if necessary.
On the MPC, pull the ejector lever that is adjacent to the MIC you are installing away
4.
from the MPC faceplate.
Align the rear of the MIC with the guides located at the corners of the MIC slot.
5.
Slide the MIC into the MPC until it is firmly seated in the MPC.
6.
280):
Figure 98 on page 278):
"Installing an MX960 MPC" on page
377).
, and then tighten completely.
S
284.
Install four screws
on bottom.
Copyright © 2017, Juniper Networks, Inc.
, and
S