Juniper MX960 Hardware Manual page 555

Copyright © 2017, Juniper Networks, Inc.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Shut down power to the router by switching the AC or DC circuit breaker for all PDMs
4.
to the off ( ) position.
O
Disconnect power from the router.
5.
Remove the cables that connect to all external devices.
6.
Remove all field replaceable units (FRUs) from the router.
7.
Attach the front and rear shipping covers.
8.
CAUTION: Apply force to any other parts of chassis other than the shipping
covers can damage the chassis.
Remove the router from the rack.
9.
Using a pallet jack with attachment:
Install the pallet jack attachment to a pallet jack. Position the pallet jack in front
of the rack, and unscrew and remove the mounting screws from the front mounting
flange on the rack.
NOTE: The pallet jack attachment fits only on a standard pallet jack.
The standard pallet jack is approximately 48 in. (121.92 cm) deep x
27 in. (68.58 cm) wide.
A minimum of four people can then slide the router onto the pallet jack by using
the handles on the shipping covers. Attach the four shipping brackets and
hardware to the pallet jack attachment. Secure the brackets to the router chassis.
Position the router in front of the shipping crate and raise the pallet jack.
Chapter 34: Packing and Returning Components
525