Installing an MX960 Dual-Wide MIC
Copyright © 2017, Juniper Networks, Inc.
Figure 154: Installing a MIC
To install a dual-wide MIC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in
"Removing an MX960 MPC" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Chapter 25: Replacing Line Card Components
Figure 101 on page
283):
Figure 100 on page
377).
S
on the bottom of the MPC.
S
on the top of the MPC.
281):
373