Installing An Mx960 Ac Power Supply - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Installing an MX960 AC Power Supply

394
To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Move the AC input switch in the chassis above the empty power supply slot to the off
2.
( O ) position.
Ensure that the release lever below the empty power supply slot is locked in the
3.
counterclockwise position (see
If necessary, pull the spring-loaded locking pin in the release lever away from the
chassis and turn the release lever counterclockwise until it stops. Let go of the locking
pin in the release lever. Ensure that the pin is seated inside the corresponding hole in
the chassis.
Using both hands, slide the power supply straight into the chassis until the power
4.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplates.
The small tab on the metal housing that is controlled by the release lever must be
inside of the corresponding slot at the bottom of the power supply (see
Figure 104 on page 292). This tab is used to pull the power supply down in the chassis
slot, prior to removing the power supply.
While firmly pushing the handle on the power supply faceplate with one hand, use
5.
your other hand to pull the spring-loaded locking pin in the release lever away from
the chassis and turn the release lever clockwise until it stops.
Let go of the locking pin in the release lever. Ensure that the pin is seated inside the
6.
corresponding hole in the chassis.
Move the AC input switch in the chassis above the power supply to the on (
7.
and observe the status LEDs on the power supply faceplate. If the power supply is
correctly installed and functioning normally, the
and the LED is not lit.
PS FAIL
Figure 104 on page 292):
Figure 104 on page 292).
and
AC OK
Copyright © 2017, Juniper Networks, Inc.
) position
—
LEDs light steadily,
DC OK