Reinstalling Components In The Mx960 Chassis After Installing It With A Lift; Reinstalling The Power Supplies After Installing The Mx960 Router With A; Lift - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Reinstalling Components in the MX960 Chassis After Installing It with a Lift

Reinstalling the Power Supplies After Installing the MX960 Router with a Lift
216
After the router is installed in the rack, reinstall the removed components before booting
and configuring the router. You reinstall components first in the rear of the chassis, and
then in the front:

Reinstalling the Power Supplies After Installing the MX960 Router with a

1.
Lift on page 216
Reinstalling the Fan Trays After Installing the MX960 Router with a Lift on page 217
2.
Reinstalling the SCBs After Installing the MX960 Router with a Lift on page 219
3.
Reinstalling the DPCs After Installing the MX960 Router with a Lift on page 220
4.
Reinstalling the FPCs After Installing the MX960 Router with a Lift on page 222
5.
Reinstalling the Standard Cable Manager After Installing an MX960 Router with a
6.
Lift on page 223
Reinstall the rightmost power supply first and then work your way to the left. To reinstall
the AC or DC power supplies, follow this procedure for each power supply (see
Figure 63 on page 217, which shows the installation of the DC power supplies):
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
For an AC-powered router, move the AC input switch in the chassis above the power
2.
supply slot to the off (
O
breaker on the power supply to the off (
We recommend this even though the power supplies are not connected to power
sources.
Ensure that the release lever below the empty power supply slot is locked in the
3.
counterclockwise position (see
If necessary, pull the spring-loaded locking pin in the release lever away from the
chassis and turn the release lever counterclockwise until it stops. Let go of the locking
pin in the release lever. Ensure that the pin is seated inside the corresponding hole in
the chassis.
Using both hands, slide the power supply straight into the chassis until the power
4.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplates.
The small tab on the metal housing that is controlled by the release lever must be
inside of the corresponding slot at the bottom of the power supply. This tab is used
to pull the power supply down in the chassis slot, prior to removing the power supply.
) position. For a DC-powered router, move the DC circuit
) position.
O
Figure 63 on page 217).
Copyright © 2017, Juniper Networks, Inc.