Powering Off The Mx960 Router - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

Powering Off the MX960 Router

Related
Documentation
242
Connecting Power to a DC-Powered MX960 Router with High-Capacity Power Supplies
on page 236
Connecting the MX960 Router to Management and Alarm Devices on page 247
Preventing Electrostatic Discharge Damage to an MX960 Router
Replacing an MX960 DC Power Supply on page 395
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
To power off the router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down the Routing Engines cleanly, so their state information is preserved. (If
the router contains only one Routing Engine, issue the
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
2.
has halted. For more information about the command, see the
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
3.
ESD points on the chassis.
Move the AC input switch on the chassis above the AC power supply or the DC circuit
4.
breaker on each DC power supply faceplate to the off (
Preventing Electrostatic Discharge Damage to an MX960 Router
Grounding the MX960 Router on page 226
Powering On an AC-Powered MX960 Router with Normal Capacity Power Supplies
on page 232
Powering On a DC-Powered MX960 Router with Normal Capacity Power Supplies on
page 240
operational mode command. The command
request system halt
CLI Explorer
) position.
O
Copyright © 2017, Juniper Networks, Inc.
command.)
.