MX960 3D Universal Edge Router Hardware Guide
Installing an MX960 MIC
370
Figure 152: Removing a Dual-Wide MIC
Ejector
Ejector
To install a MIC (see
Figure 99 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If you have used a dual-wide MIC and are now replacing it with two "single" MICs,
2.
install the septum (see
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in
"Removing an MX960 MPC" on page
Position the septum in the center of the MPC so that it lines up with holes labeled
b.
S
on the top of the MPC.
Insert a screw into each of the two holes labeled
c.
280):
Figure 98 on page
278):
377).
S
, and then tighten completely.
Copyright © 2017, Juniper Networks, Inc.