MX240 3D Universal Edge Router Hardware Guide
Related
Documentation
Connecting an MX240 AC Power Supply Cord
Related
Documentation
Connecting an MX240 DC Power Supply Cable
202
Powering On an AC-Powered MX240 Router on page 196
Powering On a DC-Powered MX240 Router on page 200
Preventing Electrostatic Discharge Damage to an MX240 Router on page 416
To connect the AC power cord:
Locate a replacement power cord with the type of plug appropriate for your
1.
geographical location (see
page
140).
Connect the power cord to the power supply.
2.
Insert the power cord plug into an external AC power source receptacle.
3.
Route the power cord appropriately. Verify that the power cord does not block the air
4.
exhaust and access to router components, or drape where people could trip on it.
Switch the AC input switch on the each power supply to the on (
5.
the status LEDs on the power supply faceplate. If the power supply is correctly installed
and functioning normally, the
LED is not lit.
Disconnecting an MX240 AC Power Supply Cord on page 317
Preventing Electrostatic Discharge Damage to an MX240 Router on page 416
AC Power Cord Specifications for the MX240 Router on page 140
MX240 AC Power Electrical Safety Guidelines and Warnings on page 444
WARNING:
Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is off, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the off position, and tape the switch handle of the circuit breaker
in the off position.
To connect a power cable for a DC power supply:
Locate a replacement power cable that meets the specifications.
1.
Verify that a licensed electrician has attached a cable lug to the replacement power
2.
cable.
Verify that the
3.
INPUT OK
"AC Power Cord Specifications for the MX240 Router" on
and
LEDs light steadily, and the
AC OK
DC OK
LED is off.
|
) position and observe
PS FAIL
Copyright © 2016, Juniper Networks, Inc.