Chassis And Interface Alarm Messages; Alarm Relay Contacts; Craft Interface Leds - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Chassis and Interface Alarm Messages

Alarm Relay Contacts

Craft Interface LEDs

488
When the Routing Engine detects an alarm condition, it lights the red or yellow alarm
LED on the craft interface as appropriate. To view a more detailed description of the
alarm cause, issue the show chassis alarms
user@host> show chassis alarms
There are two classes of alarm messages:
Chassis alarms—Indicate a problem with a chassis component such as the cooling
system or power supplies.
Interface alarms—Indicate a problem with a specific network interface.
The craft interface has two alarm relay contacts for connecting the router to external
alarm devices. Whenever a system condition triggers either the red or yellow alarm on
the craft interface, the alarm relay contacts are also activated. The alarm relay contacts
are located on the upper right of the craft interface.
The craft interface is the panel on the front of the router located above the DPC cards
that contains LEDs and buttons that allow you to troubleshoot the router.
LEDs on the craft interface include the following:
Alarm LEDs—One large red circular LED and one large yellow triangular LED, located
on the upper right of the craft interface, indicate two levels of alarm conditions. The
circular red LED lights to indicate a critical condition that can result in a system
shutdown. The triangular yellow LED lights to indicate a less severe condition that
requires monitoring or maintenance. Both LEDs can be lit simultaneously. A condition
that causes an alarm LED to light also activates the corresponding alarm relay contact
on the craft interface.
Host subsystem LEDs—Three LEDs,
of the host subsystem. A green
the master. The LED indicates that the host is online. The
ONLINE
that the host is installed but the routing engine is offline. The host subsystem LEDs are
located on the left of the craft interface and are labeled
Power supply LEDs—Two LEDs (
indicates that the power supply is functioning normally. Red indicates that the power
supply is not functioning normally. The power supply LEDs are located in the center
craft interface, and are labeled
Line card LEDs—Two LEDs,
Green indicates OK and red indicates a failure. The line card LEDs are located along
the bottom of the craft interface.
command:
, , and
MASTER ONLINE
MASTER LED indicates that the host is functioning as
) indicate the status of each power supply. Green
PEM
through .
0 3
and , indicate the status of each DPC, FPC, or MPC.
OK FAIL
Copyright © 2017, Juniper Networks, Inc.
, indicate the status
OFFLINE
LED indicates
OFFLINE
and .
RE0 RE1