Installing An Mx960 Ac Power Supply - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing an MX960 AC Power Supply

290
Press and hold the corresponding online button on the craft interface until the
green LED next to the button lights steadily, in about 5 seconds.
OK
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
To bring a PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in FPC3, use a narrow-ended tool that fits inside the opening that leads to the
button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
To bring a MIC online:
Press the MIC offline/online button until the MIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the
or the correct PIC or MIC functioning by issuing the
command.
Preventing Electrostatic Discharge Damage to an MX960 Router
Removing a Cable on an MX960 DPC, MPC, MIC, or PIC on page 386
Maintaining Cables That Connect to MX960 DPCs, MPCs, MICs, or PICs on page 466
To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Move the AC input switch in the chassis above the empty power supply slot to the off
2.
( ) position.
O
CLI Explorer
CLI Explorer
CLI Explorer
show chassis fpc
show chassis fpc pic-status
Figure 104 on page 292):
Copyright © 2017, Juniper Networks, Inc.
.
.
.
command