Rack; Figure 53: Installing The Mounting Hardware For Front-Mounting In An Open-Frame - Juniper MX960 Hardware Manual

Related
Documentation
Installing the MX960 Mounting Hardware for Center-Mounting in an Open-Frame Rack
Copyright © 2017, Juniper Networks, Inc.
Figure 53: Installing the Mounting Hardware for Front-Mounting in an
Open-Frame Rack
Large
mounting shelf
After the mounting hardware is installed, proceed to
a Mechanical Lift" on page
Installing the MX960 Mounting Hardware for a Four-Post Rack or Cabinet on page 195
Installing the MX960 Mounting Hardware for Center-Mounting in an Open-Frame Rack
on page 199
MX960 Rack-Mounting Hardware on page 14
Before center-mounting the router in an open-frame rack, you must install the large
mounting shelf on the rack. The small mounting shelf is not needed.
Table 97 on page 200 specifies the holes in which you insert screws to install the mounting
hardware in an open-frame rack (an
distances are relative to one of the standard U divisions on the rack. For reference, the
bottom of all mounting shelves is at 0.04 in. (0.02 U) above a U division.
Chapter 15: Installing the Mounting Hardware
Open-frame

rack

"Installing the MX960 Router Using
214.
indicates a mounting hole location). The hole
X
199