Powering Off The Mx960 Router - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
424
Verify that the system runs Junos OS Release 13.3 or later by issuing the show version
1.
command on the master router.
user@host> show version
Model: mx960
Junos Base OS Software Suite [13.3-yyyymmdd];
...
NOTE: The SCBE2 is supported only on:
Junos OS Release 13.3 or later
Network Services Mode: Enhanced-IP
The latest software ensures a healthy system—that is, a system that comprises Routing
Engines, control boards, and FPCs—before the upgrade.
For information about how to verify and upgrade the Junos OS, see the Junos OS
Installation and Upgrade Guide.

Powering Off the MX960 Router

NOTE: After turning off the power supply, wait at least 60 seconds before
turning it back on.
To power off the MX960 router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down the Routing Engines cleanly, so that their state information is preserved.
(If the router contains only one Routing Engine, issue the
command.)
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
2.
has halted.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
3.
the strap to one of the ESD points on the chassis.
Move the AC input switch on the chassis above the AC power supply or the DC circuit
4.
breaker on each DC power supply faceplate to the off
operational mode command. The command
request system halt
position.
(O)
Copyright © 2017, Juniper Networks, Inc.