Replacing The Management Ethernet Cable On An Mx Series Router; Figure 116: Auxiliary And Console Ports - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing the Management Ethernet Cable on an MX Series Router

312
connector. One RJ-45/DB-9 cable is provided with the router. If you want to connect a
device to both ports, you must supply another cable.
To replace a cable connected to a management console or auxiliary device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the port.
2.
Disconnect the cable from the console or auxiliary device.
3.
Plug the RJ-45 end of the replacement serial cable into the
4.
Figure 116 on page 312 shows the external device ports on the Routing Engine.
Plug the female DB-9 end into the console or auxiliary device's serial port.
5.

Figure 116: Auxiliary and Console Ports

Preventing Electrostatic Discharge Damage to an MX960 Router
Replacing the Management Ethernet Cable on an MX Series Router on page 312
Routing Engine Interface Cable and Wire Specifications for MX Series Routers on
page 142
Replacing an MX960 Routing Engine on page 333
One Ethernet cable with RJ-45 connectors is provided with the router. To replace the
cable connected to the
ETHERNET
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the port.
2.
Figure 117 on page 313 shows the connector.
Disconnect the cable from the network device.
3.
port:
Copyright © 2017, Juniper Networks, Inc.
or port.
CONSOLE AUX