Installing A Cable On An Mx960 Dpc, Mpc, Mic, Or Pic - Juniper MX960 Hardware Manual

Installing a Cable on an MX960 DPC, MPC, MIC, or PIC

Copyright © 2017, Juniper Networks, Inc.
For more information about the command, see the
Unplug the cable from the cable connector port. If the PIC uses fiber-optic cable,
3.
immediately cover each transceiver and the end of each cable with a rubber safety
cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
Remove the cable from the cable manager and detach it from the destination port.
4.
To install a cable:
Have ready a length of the type of cable used by the component. For cable
1.
specifications, see the
MX Series Interface Module Reference
If the cable connector port is covered by a rubber safety cap, remove the cap.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
Insert the cable connector into the cable connector port on the component faceplate.
3.
Arrange the cable in the standard or extended cable manager to prevent it from
4.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop. Placing fasteners on the loop helps to maintain its shape.
Chapter 25: Replacing Line Card Components
.
CLI Explorer
.
387