Installing Components; Installing The Mx960 Craft Interface; Chapter 21 Installing Components - Juniper MX960 Hardware Manual

CHAPTER 21

Installing Components

Installing the MX960 Craft Interface

Copyright © 2017, Juniper Networks, Inc.
Installing the MX960 Craft Interface on page 265
Installing the MX960 Air Filter on page 266
Installing an MX960 Fan Tray on page 267
Installing an MX960 Routing Engine on page 269
Installing an MX960 DPC on page 271
Installing an MX960 FPC on page 275
Installing an MX960 MIC on page 278
Installing an MX960 Dual-Wide MIC on page 281
Installing an MX960 MPC on page 284
Installing an MX960 PIC on page 286
Installing a Cable on an MX960 DPC, MPC, MIC, or PIC on page 289
Installing an MX960 AC Power Supply on page 290
Installing an MX960 DC Power Supply on page 293
Installing an MX960 AS MLC on page 297
Installing an MX960 AS MSC on page 299
Installing an MX960 AS MXC on page 301
Installing an MX960 SCB on page 302
Installing an SFP or XFP Transceiver into an MX960 DPC, MPC, MIC, or PIC on page 304
To install the craft interface (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
2.
with the other hand to support its weight.
Orient the ribbon cable so that it plugs into the connector socket. The connector is
3.
keyed and can be inserted only one way.
Figure 90 on page 266):
265