Copyright © 2017, Juniper Networks, Inc.
Loosen the captive screw on the cable restraint on the lower edge of the power supply
9.
faceplate.
Carefully move the power cables out of the way.
10.
While grasping the handle on the power supply faceplate with one hand, use your
11.
other hand to pull the spring-loaded locking pin in the release lever away from the
chassis and turn the release lever counterclockwise until it stops.
Let go of the locking pin in the release lever. Ensure that the pin is seated inside the
12.
corresponding hole in the chassis.
Pull the power supply straight out of the chassis.
13.
WARNING:
Do not touch the power connector on the top of the power
supply (see
Chapter 26: Replacing Power System Components
Figure 165 on page
398). It can contain dangerous voltages.
397