MX960 3D Universal Edge Router Hardware Guide
328
Simultaneously pull the two releases labelled PULL on the cable manager. Lift it
b.
up and outward to lock it in place.
Loosen the captive screw on each side of the fan tray faceplate.
3.
Grasp both sides of the fan tray, and pull it out approximately 1 to 3 inches.
4.
WARNING:
To avoid injury, keep tools and your fingers away from the fans
as you slide the fan tray out of the chassis. The fans might still be spinning.
Pause for approximately 15 seconds to allow the fans to stop spinning.
5.
When the fans stop spinning, press on the two latches located on the inside of the
6.
fan tray.
Place one hand under the fan tray to support it, and pull the fan tray completely out
7.
of the chassis.
Figure 127: Removing an Upper Fan Tray
Copyright © 2017, Juniper Networks, Inc.