Supplies; Figure 73: Connecting Dc Power To The Mx960 Router - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation
Connecting Power to a DC-Powered MX960 Router with High-Capacity Power Supplies
236

Figure 73: Connecting DC Power to the MX960 Router

DC Power Cable Specifications for the MX960 Router on page 185
Preventing Electrostatic Discharge Damage to an MX960 Router
Powering On a DC-Powered MX960 Router with Normal Capacity Power Supplies on
page 240
To install an MX960 DC high-capacity DC power supply:
Verify that the power switch on the power supply is in the off (
1.
On the power supply, rotate the metal cover away from the input mode switch to
2.
expose the switch.
Move the input mode switch to position 0 for one feed or position 1 for two feeds (see
3.
Figure 74 on page 237).
NOTE: For a fully redundant configuration in two-feed mode, eight feeds
are required. For a non-redundant configuration, four feeds are required.
) position.
O
Copyright © 2017, Juniper Networks, Inc.