Figure 94: Installing A Routing Engine - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation
270
Slide the Routing Engine into the SCB until you feel resistance, and then press the
5.
Routing Engine's faceplate until it engages the connectors.
Press both of the ejector handles inward to seat the Routing Engine.
6.
Tighten the captive screws on the left and right of the Routing Engine.
7.
Connect the management device cables to the Routing Engine.
8.
The Routing Engine might require several minutes to boot.
After the Routing Engine boots, verify that it is installed correctly by checking the
RE0 , and RE1 LEDs on the craft interface. If the router is operational and the Routing
Engine is functioning properly, the green
lights steadily instead, remove and install the Routing Engine again. If the red
still lights steadily, the Routing Engine is not functioning properly. Contact your customer
support representative.
To check the status of the Routing Engine, use the CLI command:
user@host> show chassis routing-engine
Routing Engine status:
For more information about using the CLI, see the Junos OS documentation.

Figure 94: Installing a Routing Engine

Preventing Electrostatic Discharge Damage to an MX960 Router
Replacing Connections to MX960 Routing Engine Interface Ports on page 343
Removing an MX960 Routing Engine on page 333
MX960 Routing Engine Description on page 29
LED lights steadily. If the red
ONLINE
Slot 0: Current state
Copyright © 2017, Juniper Networks, Inc.
,
FAIL
LED
FAIL
LED
FAIL
Master ...