Figure 181: Removing An Mx960 Ac Power Supply - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
474
Pull the power supply straight out of the chassis as shown in
6.
WARNING: Do not touch the power connector on the top of the power
supply. It can contain dangerous voltages.
Repeat steps 1-6 for power supplies in slot 1, 2, 3 where present.
7.

Figure 181: Removing an MX960 AC Power Supply

Remove the blank panel over the power distribution modules. Store for later reuse. Use
the following procedures to install the MX960 high-capacity DC power supplies for power
supply in slots 0, 1, 2, and 3, where present.
Figure 161 on page
Copyright © 2017, Juniper Networks, Inc.
393.